이벤트 배너 상단 이벤트 배너

전체 카테고리

추천 메뉴

공지사항


[ACECO SC-1] 2.8GHz 휴대형 주파수 카운터, Handheld Frequency Count
위 상품 이미지는 참조용 대표 이미지이며,
정확한 사양은 데이터시트에서 확인하셔야 합니다.
[ACECO SC-1] 2.8GHz 휴대형 주파수 카운터, Handheld Frequency Count

[ACECO SC-1] 2.8GHz 휴대형 주파수 카운터, Handheld Frequency Count

공유
SNS 공유하기

  • 페이스북

  • 트위터

  • 핀터레스트

  • 카카오스토리
  • 모델명
    SC-1
  • 짧은설명
    SC-1 - 30MHz ~ 2.8GHz,핸드형 무선 주파수 카운터
  • 브랜드
  • 정상판매가
    385,000원(수량한정 판매)
  • 배송비
    0원 조건별배송
    금액별배송비
    0원 이상 ~ 110,000원 미만 3,500원
    110,000원 이상 0원

    배송비 계산 기준 : 판매가 + 옵션가 + 추가상품가 + 텍스트옵션가 - 상품할인가 - 상품쿠폰할인가

    지역별추가배송비
    지역별배송비
    제주특별자치도 서귀포시 3,500원
    제주특별자치도 제주시 3,500원
    경상북도 울릉군 3,500원
    택배  /  주문시결제(선결제)
    방문 수령지 : 서울특별시 금천구 범안로 1142 (하우스디더스카이밸리가산2차) 1207호
[ACECO SC-1] 2.8GHz 휴대형 주파수 카운터, Handheld Frequency Count
0
  • 총 상품금액
  • 총 할인금액
  • 총 합계금액
※네이버페이 주문 시에는 상품할인이 적용되지 않습니다.
info

SC-1

 

 

The Aceco SC-1 hand-held radio frequency counter is compact, truly pocket-sized, versatile test instrument designed for measuring any digital, on/off keying or analog signal on frequencies between 30 MHz and 2.8 GHz. Supplied as a complete with internal NiCd pack, AC wall charger and 7 section telescopic antenna. 

 

 

◆ 7 digit Liquid Crystal Display

◆ Frequency counter for digital, on/off keying and analog signals with a minimum pulse width of 250 uS.

◆ Ultra sensitive synchronous detector - 16 section bargraph to show RF signal strength    (-35dBm to 0dBm)

 Two range positions - the 1 GHz position for frequencies between 30 MHz and 0.8 GHz and the 2.8 GHz position for frequencies between 500 MHz and 2.8 GHz.

◆ Squelch adjustment for input signals

◆ Hold switch to lock display

◆ Low battery indicator

◆ Low power consumption (Average 5 hour battery life)

 

Controls

 

◆ SQL Knob - This knob turns the RF counter on and tunes the squelch up or down to set the signal strength for reception.

◆ Range Switch - This should be switched to the 1 GHz position for frequencies between 30 MHz and 0.8 GHz and switched to the 2.8 GHz position for frequencies between 500 MHz and 2.8 GHz.

◆ Hold Button - This holds the current display and stops the counter from counting.

◆ Calibration - The calibration adjustment opening is located on the front panel of the counter. This allows access to the trimmer capacitor that provides about a 10 PPM adjustment range of the time base oscillator. This is not usually necessary but to do so read a signal of a known frequency before adjusting the trimmer for correct frequency display. If you calibrate at 4.1943 MHz or above then the counter will be more accurate.

  

Warranty

 

Aceco Electronics, Corp. guarantee the RF counter and its accessories for one year against defects in manufacture. This warranty does not cover items that have been modified, subject to unauthorized repairs, misuse or abuse. This warranty does not cover damage caused by excessive power levels applied to the signal input.

Never make any kind of connection between the RF counter and a transmitter.

 

Hints And Tips


1. NiCd Operation

This RF counter can operate for up to six hours from its fully charged NiCd batteries. They are charged when the unit is plugged into the supplied AC/DC adapter. Full recharge will occur over 12 to 16 hours. Before recharging the batteries you should be deep cycled occasionally by allowing them to completely discharge to maintain maximum battery capacity. The NiCd batteries should last for several years. However, it is a good idea to check them every twelve months for signs of corrosion or leakage. Always replace the whole set if any one cell fails.

2. Signal Input

When using the RF counter with an antenna for signal pick up, random frequencies may appear on the display. This is quite normal and is caused by the high gain of the receiver circuits, which amplify noise in the absence of a strong readable signal. Never get the unit too close to a transmitter as internal damage will result.

3. Antenna Selection

The supplied telescopic antenna is best for general purpose use. This is because its length can be adjusted to suit the frequency required. Usually you will want a shorter antenna for UHF and a fully extended one for VHF / HF.

4. Reception Distance From Transmitter

The distance from which you will be able to receive frequencies will depend upon the type and location of the transmitting antenna, transmitter output power and the frequency in use.

 

 

Product Specifications>

SC-1 Product Specifications
 


 

 

 > 휴대형 주파수 카운터, ACECO, SC-1, RF Frequency Counter,  Handheld Frequency Counter

 

이미지 확대보기

[ACECO SC-1] 2.8GHz 휴대형 주파수 카운터, Handheld Frequency Count

[ACECO SC-1] 2.8GHz 휴대형 주파수 카운터, Handheld Frequency Count
[ACECO SC-1] 2.8GHz 휴대형 주파수 카운터, Handheld Frequency Count

비밀번호 인증

글 작성시 설정한 비밀번호를 입력해 주세요.

확인

장바구니 담기

상품이 장바구니에 담겼습니다.
바로 확인하시겠습니까?

찜 리스트 담기

상품이 찜 리스트에 담겼습니다.
바로 확인하시겠습니까?

광고 스크롤 좌측 배너
최근본상품
0/0
상단으로 이동